Are you unable to play Bioshock because you can’t hear anything at all? Maybe this might help you. But first, let me give you quick specs of my computer:
- Windows 7 Home Premium 64-bit
- ASUS P6T
- Onboard Realtek ALC1200 which is using HD audio software and drivers, downloaded from the ASUS support website
- Audio ports on the motherboard and in the front of the Antec 1200 case via wire from port to motherboard
- Bioshock purchased and downloaded via Steam
History of the problem
I first encountered this problem while I was using Windows 7 Ultimate RC. The sound in the game worked just fine until after the plane crash at the beginning of the game. Of course, I googled for the problem and it took me some time. Most suggestions had to do with downloading and installing Windows Visual Basic 2008 Redistributable. There were also suggestions to download an older version of Direct X 9. When Bioshock was installed, it also installed an older version of Direct X and Windows Visual Basic 2005 Redistributable.
None of these suggestions worked for me. I eventually found this solution via an obscure forum posting. For the life of me, I cannot remember the address so just take note that I did not come up with this solution all on my own. 😀
Just remember that if you are not using Realtek HD audio, this might not work. Not everyone’s specs are the same. It doesn’t hurt to try this. Oh, and I am not responsible for any damage that might occur for whatever reason.
In the notification/status area of the taskbar, right click on the Realtek HD Audio icon and select “Audio devices”. From here, a window will popup. This window should have four tabs: “Playback”, “Recording”, “Sounds” and “Communications”. Even if it doesn’t have 4 tabs, make sure that it at least has the “Recording” tab.
Click on the “Recording” tab. In the picture to the left, I have two devices which are currently “not plugged in”. Now, right-click inside this window and select “Show disabled devices”. Any device that is disabled should appear in this window. Now right-click either “Stereo Mix” or “CD Audio” and select “Enable”. A green circle with a checkmark should appear next to the device. The picture below shows the disabled devices and the right-click menu to enable them.
Now you should be able to hear sounds in Bioshock after the plane crash. These are pretty exact instructions for a setup with Realtek HD audio. So, no one should mess this up. If this does not work, then you might be experiencing a problem somewhere else.